 |
From the manufacturer:
The Racing Beat RX-8 header is constructed using 100% stainless steel for superior quality, performance and appearance. Our exclusive cast stainless-steel mounting flange has been designed to allow the smooth transition of the exhaust gas flow from the engine to the primary tubing. Incorporated into the flange design are critical emission control air passages that were included on the OEM flange design. These small passages allow air to be pumped into the exhaust ports to aid in more efficient catalytic converter function. While this header is not considered “emissions legal” for street use, our header does not remove any catalytic converters, and is equipped with an oxygen sensor fitting and retains all emissions control functionality.
The Racing Beat Header utilizes 1.75” OD, 14 gauge (.083"), mandrel-bent, 304 stainless steel tubing and features an exclusive Racing Beat engine-to-header flange. All required mounting hardware, an outlet gasket, and instructions are included. A engine-to-header gasket is NOT supplied with the kit, but the stock unit can be re-used unless it shows signs or damage, leakage, or extended wear.
As developed and tested on our engine dyno, the Racing Beat header produced a peak horsepower improvement of over 4 HP.
NOTE: Legal in California only for racing vehicles, which may never be used upon a highway.
*Add approximately one week to the expected ship date for International orders
This item cannot be shipped to a PO Box |
|
|
